JETI model Duplex DS-16 - Page 36

computer radio control system
EN
2.2.
6
8. Unscrew the upper part of the stick assembly (anticlockwise).
9. Insert the connecting wires through the hollow opening of the
transmitter stick.
8
9
10. Adjust length of the stick to suit your flying style. (See 4.3)
After installation of the optional stick ends with switch or
button, make sure that while adjusting the stick length
Note:
10
11
12
13
6. Remove both installation machine screws for each of the
control stick assemblies.
7. Carefully remove both control stick assemblies. Gently lift in
your direction (toward the transmitter back side).
2
3
4
XXX
YYY
SSS SSS
YYY
XXX
XXX
YYY
SSS
5
7
35