computer radio control system
EN
4. 4.
button to exit the free mix screen. If you need to make any changes
simply highlight the desired free mix and press the “F4 (Edit)”
button to reach the advanced settings menu for that free mix.
a). Free Mix Setting
The free mix configuration settings can be set collectively for all
flight modes by selecting the “G-(globe)” symbol or you can allow
individual free mix settings in each separate flight mode by
sellecting the “S-Separate” symbol.
b) Free Mix Activation
A free mix can be activated by any Switch/Knob/Stick. By selecting
“Switch” and by editing the desired assignment you can activate
and choose the position at which this Switch/Knob/Stick or Logical
Switch will turn the mix ON or OFF or even control its throw
proportionally. This menu line includes a visual graphic to show the
ON or OFF position of your selected switch. If you do not select any
switch, then the mix is always ON.
c) Free Mix Curve Programming
This programming screen can be accessed by highlighting the
“Curve” item and by either using the “3D Control” button or by
pressing the “F4 (Curve)” button. By accessing the “Mixer Curve”
function screen you can select the mix curve which best fits your
application.
d) Free Mix Deployment Delay
The time delay function can help smooth the transition from one
state to another. Values adjusted in the “Source” item will slow
down full mix deployment when the mix is ON (switched ON or
always ON) and the master channel changes its value. In this item,
when you add a delay to only one side (- or +), the mix deployment
will be slow in one direction only (-100% to 100%) or (100% to -
100%). When you add a delay to both the negative (-) and the
positive (+) sides, then your mix will be slowed in both throw
directions.
e) Free Mix Activation/Deactivation Delay
The „Switch“ values can only be when you have assigned a switch to
turn the mix ON and OFF. This delay operates independently from
the „Source“ values. The positive side of a delay is applied if the mix
is activated using Activation Switch. The negative side is used if the
mix is deactivated and both slow down any fast reactions while
turning the mix ON and OFF.
a
c
b
d
e
h
i
j
g
95
To Next Page
Loading...
Need help?
General
