115
7. Rotate the wheel until the inner weight will be in front of the laser pointer.
Press the "-/+" arrow button to adjust the laser dot to the correct
position.
IMPORTANT! The laser dot must be adjusted in front of the weight.
8. Once the laser dot is adjusted to the correc place press the “RETURN” button to store the inner laser position.
9. Then the laser dot will move to the outer plane.
10. Repeat the same procedure as described above from point 7, to adjust
the laser dot position.
11. Once the laser dot is adjusted to the correct place press the button “RETURN” to store the outer laser
position.
12. Press “STOP” button to exit the service code.
Comments:None
To Next Page
Loading...