iSTAR Edge G2 Controller Installation and Configuration Guide 66
Chapter 8 - iSTAR Web Page
Diagnostics page icon
Device icon
iSTAR Controller icon
Menu icon
Refresh icon
Opening and Closing Edit Mode
Click the edit icon in the top-right corner of the iSTAR Web Page to open edit mode to edit fields on the iSTAR Web Page.
Click the save icon in the top-right corner to save any changes made. Click the close icon to exit edit mode.
Switching between Configuration and Diagnostic Mode
• Select Configuration or Diagnostics from the Home screen.
• Click on the menu icon in the top-right corner and select Configuration or Diagnostics.
• Click on the information icon on the top-right corner to open a dialog box displaying controller and build information and
online help.
Navigating the iSTAR Web Page
Navigate by clicking on the tabs on the tab bar.
General
You can configure iSTAR panels from the General tab on the Configure page. See Configuring Clusters and Controllers on
Page 68 for more information.
Advanced
You can perform the following actions in the Advanced tab:
• Reboot the panel.
• Check current firmware version.
• Request ECC Certificate.
802.1x
Select 802.1x authentication (PEAP, TLS, or none) by enabling edit mode, opening the dropdown box to select your preferred
authentication method, then clicking the save icon to save your selection.
To Next Page
Loading...
