iSTAR Edge G2 Controller Installation and Configuration Guide 79
Chapter 9 - Diagnostics
Ethernet Port Test
The onboard Ethernet tests display diagnostic information about Ethernet connections.
To test the Ethernet port, set switch SW1 to 8 and observe the LCD display for test results.
If the Ethernet card passes the diagnostic test, the following is displayed on the LCD:
Ethernet PC Card
* Passed *
When the test is complete, set SW1 back to 0 or F to display status messages.
NOTE
The LCD only displays success messages. If no message displays, the circuit is defective or the port is not communicating.
To Next Page
Loading...
