ņ23
[I] Method of Displaying Target Data [TGT DATA]
Procedure 1 Move the cross cursor mark onto the target for which numeric data is to
be displayed, and press the [TGT DATA] key.
Or, set the cursor mode to TGT Data, place the cross cursor over the
target whose numerical data is to be displayed, and press the [ENT] key.
Then, the data of the designated target will appear, it will be marked with a symbol “
”.
The target data will remain on the radar display until the target is lost and its vector
disappears, or until another target is designated.
If a target with the mark “
” is designated, only its true bearing (BEARING) and range
(RANGE) will appear until its vector appears.
[II] Canceling numerical data display (CNCL Data)
Procedure 1 Set the cursor mode to TGT Data, place the cross cursor over the tracked
target whose numerical data is to be displayed, and press the [CLR/INFO]
key.
Numerical data display is canceled.
To Next Page
Loading...
