3.5 GENERAL OPERATIONS
3ņ66
3
y
y y
3.5.20 Automatic Acquisition
Note: If the number of targets being tracked has reached the allowable maximum and other targets (not
being tracked) go into the acquisition/activation zone, automatically acquired targets are canceled
in ascending order of danger.
Turning On / Off the automatic acquisition and AIS activation (AZ Menu)
Procedure 1 Press the [TT Menu] key.
TT Menu opens.
2 Press the [5] key.
Press the [1] key.
Acquisition / activation zone setting menu (AZ)
opens.
3 Press the [1] or [2] key.
The acquisition / activation zone 1 (AZ1) or
acquisition / activation zone 2 (AZ2) will be set
to on or off.
On :The acquisition / activation zone is
turned on. The mark " " and target
ID number are put to an acquired target
and move with the target. The vectors are displayed within 1 minute.
AIS targets are activated.
Off :The acquisition/activation zone is turned off.
The acquisition/activation zone will disappear from the radar display, but the
system continues to track the acquired target.
The activated AIS targets remain activate.
To Next Page
Loading...
Need help?
General
