EasyManuals Logo

JRC JMA-5208HS User Manual

JRC JMA-5208HS
540 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
3ņ3
Procedure 1 Check that the ship’s mains are turned on.
2 Press [STBY] key.
The system is turned on, and the preheating time is displayed.
PREHEAT is indicated at the upper left of the radar display.
3 Wait until the preheating time is over.
When the preheating time is over, the preheating time screen disappears, and PREHEAT
at the upper left of the radar display changes to STANDBY .
4 Press [TX/PRF] key.
The radar will start transmission and the antenna will start rotating.
STANDBY at the upper left of the radar display changes to TRANSMIT .
Note: The radar does not start transmission if you press [TX/PRF] key while PREHEAT is
indicated.
3.1.2 Observe and Adjust Video
Procedure 1 Press [RANGE+] key or [RANGE-] key to set the range to the scale
required for target observation.
2 Turn the controls [AUTO-GAIN], [AUTO-SEA], and [RAIN] to obtain the
clearest targets.
Refer to
[GAIN]ЍSection 3.4.5 “Control Sensitivity [GAIN/PL]”
[SEA]ЍSection 3.4.6 “Suppress Sea Clutter [AUTO-SEA]”
[RAIN]ЍSection 3.4.7 “Suppress Rain/Snow Clutter [AUTO-RAIN]”
for how to use each control.

Table of Contents

Other manuals for JRC JMA-5208HS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JRC JMA-5208HS and is the answer not in the manual?

JRC JMA-5208HS Specifications

General IconGeneral
BrandJRC
ModelJMA-5208HS
CategoryMarine Radar
LanguageEnglish

Related product manuals