ņ41
7.4.2 Adjustment of Target Tracking Function (TT)
[I] Vector Constant Adjustment (Vector Constant)
Adjust the vector follow-up performance of the target tracking function.
The vector constant is adjusted to an optimal value, so do not change it carelessly.
z Do not change the set value carelessly.
The vector constant shall be set to 4 normally. If the
vector constant value is higher, a target’s vector will
be better followed up when the target and own ship
change their course or speed, but the vector
accuracy will be lower on the contrary.
Attention
CAUTION
Optimal values have been set for Video Level and
Vector Constant; therefore, never change their values
unless absolutely necessary. Failure to comply may
result in accidents that would lower target tracking
performance.
