- xxii -
3.8.4 Set Navigation Information (User Map Setting) ................................. 3-92
3.8.5 Set and Display Geodetic System ..................................................... 3-99
3.9 APPLIED OPERATIONS ..................................................................... 3-101
3.9.1 Set Radar Signal Processing (Process Setting) .............................. 3-101
3.9.2 Set Radar Trails (RADAR Trails Setting) ......................................... 3-104
3.9.3 Set Cursor (Cursor Setting) ............................................................. 3-109
3.9.4 Set Screen(Screen Setting) ............................................................. 3-111
3.9.5 Set Scanner (TXRX Setting) ........................................................... 3-121
3.9.6 Set Chart Display (Map Setting) ...................................................... 3-123
3.9.7 Set LORAN C (LORAN C Correction) ............................................. 3-135
3.10 USE FUNCTION SWITCH [FUNC] ..................................................... 3-136
3.10.1 Operation Procedure ..................................................................... 3-136
3.10.2 Function Setting Menu Items ......................................................... 3-137
3.10.3 Overview of Function Operations .................................................. 3-138
3.10.4 Overview of Stored Function Setting Data .................................... 3-142
3.10.5 Personal Information (PIN Setting) ................................................ 3-143
3.11 USING CARD ...................................................................................... 3-146
3.11.1 Save in and Transfer to Card (MEM CAPA/Copy) ......................... 3-147
3.11.2 Erase/Initialize Card Memory (CLR MEM/INIT Card) .................... 3-152
4. MEASUREMENT OF RANGE AND BEARING
4.1 MEASUREMENT USING THE CURSOR WITH THE TRACKBALL ........ 4-1
4.2 MEASUREMENT BY RANGE RINGS ..................................................... 4-2
4.3 MEASUREMENT BY EBLS AND VRMS ................................................. 4-3
4.4 MEASUREMENT BETWEEN TWO OPTIONAL POINTS ....................... 4-4
5. OPERATION OF TT AND AIS
5.1 PREPARATION ....................................................................................... 5-2
5.1.1 Collision Avoidance ............................................................................. 5-3
5.1.2 Definitions of Symbols ......................................................................... 5-6
5.1.3 TT Data Display ................................................................................. 5-10
5.1.4 Cursor Modes (Cursor) ...................................................................... 5-12
5.1.5 Setting Collision Decision Criteria (CPA/TCPA Limit) ........................ 5-13
5.1.6 Setting CPA Ring (CPA Ring) ............................................................ 5-14
5.1.7 Setting Vectors (Vector Time) .......................................................... 5-15
5.1.8 Setting the GPS antenna location ................................................... 5-16
5.2 TT OPERATION .................................................................................... 5-17
To Next Page
Loading...
Need help?
General
