ņ43
Displaying numeric data
Procedure 1 Press the CURSOR button at the upper right of the radar display
several times until
TGT DATA appears.
The cursor mode is set to the numeric data display mode.
2 Move the cross cursor mark onto the active AIS target for which numeric
data is to be displayed, and press [ENT] key.
The values of the selected AIS target will appear on the right side of the radar display.
The mark
is displayed around the symbol.
Reference: If the values are displayed but the mark
. is not on the radar display, the target is outside the
radar display.
Clearing numeric data
Procedure 1 Press the Cursor button at the upper right of the radar display several
times until TGT Data appears.
The cursor mode is set to the numeric data display mode.
2 Move the cross cursor mark onto the active AIS target for which numeric
data is to be cleared, and press [CLR] key.
The values of the selected AIS target will be cleared from the right side of the radar
display, and the mark
displayed around the symbol will also disappear.
To Next Page
Loading...
