ņ55
[II] Reading of Internal Settings from Card (Card to Internal)
Read the saved memory data from the flash memory card into the system memory.
Perform the read operation in order to return the system to the previous operation condition after replacement of
the radar processing circuit in the system.
Procedure 1 Insert the memory flash card, in which
internal settings have been saved, into
Card slot 2.
The lower slot is slot 1; the upper slot is slot 2.
2 Hold down [RADAR MENU] key.
The Code Input Menu will appear.
3 Press [0] key.
4 Move the cursor onto the “ENT” button
in the Code Input menu, and press
[ENT] key.
The Adjust Menu will appear.
5 Press [2] key.
The Maintenance Menu will appear.
6 Press [5] key.
The execution check window will open to check whether or not you want to read the
internal settings from Card2.
1 YES: Read
2 NO: Cancellation
If YES is selected, the memory data is read from the flash memory card into the system
memory.
After the internal memory area is updated, the system is restarted.
To Next Page
Loading...
Need help?
General
