7 To cancel input, put the cursor on CLR and then press the [ENT]
key.
The latitude / longitude input menu will close without reflecting the set value to the
operating state.
Character input screen
Enter button
Back Space button
Delete button
Character/Number button Entered character
Exit button
Entering a character
Procedures 1 On the character input menu, use trackball to select alphabet from A
to Z, numbers from 0 to 9, or symbols (only comments for mark / line),
and then press the [ENT] key to enter one character of the name to be
inputted.
For example, JRC for a name, click button as follows:
J → R → C
2 Make sure that the entered character is correct, put the cursor on
ENT , and then press the [ENT] key.
The character has been entered.
3 To cancel input, put the cursor on Exit , and press the [ENT] key.
The character input menu will be closed without entering the character.
3-19
To Next Page
Loading...
Need help?
General
