5.7 Trial Maneuvering
yy
yyy
5.8.4 Canceling Plotted Target Data
The system cancels the display of specified plotted target data.
Once plotted target data is canceled, it cannot be re-saved any more.
Procedures 1 Press the [ACQ] key.
2 Enter the plot number for cancellation, pressing [0] to [9].
3 Press the [TGT CNCL] key.
The plotted target data of the specified plot number will be canceled.
Canceling all plotted targets
5
Procedures 1 Press the [TGT CNCL] key for 5 seconds or more.
The plotted targets of all the plot numbers will be canceled.
5.8.5 Displaying Numeric Data of Plotted Targets
The following data is displayed for a specified plotted target:
TGT ID Plot number
BRG Bearing :0.1° unit
Range Range :0.01 nm unit
Course Target’s true course :0.1° unit
Speed Target’s true speed :0.1 kn unit
CPA CPA :0.01 nm unit
TCPA TCPA :0.1 min unit
TIME Elapsed time :0.1 min unit
Procedures 1 Press the [TGT DATA] key.
2 Enter the plot number pressing [0] to [9].
3 Press the [ENT] key.
The data of the specified plot number will be displayed.
The mark of the target for which numeric data is displayed is changed into “
”.
5-66
To Next Page
Loading...
Need help?
General
