Editing a mark or line
Procedures 1 Open the input list for the Mark / Line List menu.
2 Press the [2] key to select the mark list or line list.
The Mark Input menu and the Line Input menu are switched.
3 Press the [1] key.
The input list will appear.
4 Turn the [MULTI] dial to show the number for a mark or line to be
changed in reverse video.
Holding down the [RANGE + / - ] key for at least two seconds will enable scroll.
5 Press the [MULTI] dial.
The list of the mark font or line type will be displayed.
6 Press numeric keys corresponding to the desired mark font or line
pattern.
The mark font or line type is changed.
7 In the same manner, enter the color of the mark or line, latitude /
longitude, and comments.
Use the numeric keys, latitude / longitude, and the character input screen for entry.
For the input method on the latitude / longitude and character input screens, see
Section 3.3.4.
To edit or add another mark or line, repeat procedures 2 to 5.
3-71
To Next Page
Loading...
Need help?
General
