JRC NWZ-4610 - Page 41

4-19
4.5.4.4. SETP3 Selecting display contents
Select as many display contents as the number of screens that are created by segmentation. For
instance, for a 2-segmentation screen, select the display content for one half of the screen and then
select the display content for the other half of the screen (see the diagram below).
The display content of a customized screen is divided according to the category. Initially, select a
category and a display item. "Table4-1 shows the categories and display contents".
A special screen and a graphic screen are not classified according to the category.
Only the integer part or a decimal part of some item that is selected on a 1-segmentation customized
screen can be expanded (Display mode).
If display content selection is set to “OFF”, no information is displayed in the area.
Set the auto screen function and display mode (only segmentation 1 screen) in STEP3. The following
functions can be set.
1-1) AUTO SCREEN: ON – Enables the auto screen function.
OFF – Disables the auto screen function.
1-2) SOUND : SOUND1 – The buzzer of "Pippi" sound is sounded at the time of a screen
change.
SOUND2 – The buzzer of "Pip" sound is sounded at the time of a screen
change.
OFF – Does not emit a buzzer sound even if the screen is switched.
1-3) TIME: Sets a screen switching time. A time of up to 10 seconds can be set.
2-1) DISPLAY MODE： normal It displays in the character of the same size.
special 1 Only integer part is expanded and displayed.
special 2 Only a decimal part is expanded and displayed.
auto range Integer part or a decimal part is expanded and it displays the
optimal.
Example) Procedure for selecting display contents for a 2-segmentation screen
Screen structure
Selecting display contents for 2-segmentation screen
Procedure
1. Select a screen structure by referencing “STEP1” and “STEP2”.
Customized screen
2. Select a screen section to be displayed by using
and press .
Select the screen section from the following:
segmentation1 screen: “DISPLAY’
segmentation2 screen: “DISPLAY 1/2” “DISPLAY 2/2”
segmentation3 screen: “DISPLAY 1/3” “DISPLAY 2/3” “DISPLAY 3/3”
segmentation4 screen: “DISPLAY 1/4” “DISPLAY 2/4” “DISPLAY 3/4” “DISPLAY 4/4”
: Select display
contents of the
1/2 screen
 Select display
contents of the
2/2 screen.
: Select a
category of the
1/2 screen
: Select a
category of the
2/2 screen.