4-2-7. Reverse feed stitching (at end) pattern
A stitch shape of reverse feed stitching (at end) is set by following the steps of procedure described
below.
(1) Enabling the reverse feed stitching (at end) pattern
①
Displaying the edit screen for reverse feed stitching (at end)
Keep
❶
held pressed for one sec-
ond. The reverse feed stitching (at end) edit
screen is displayed.
②
Setting the shape, the number of stitches and pitch of reverse feed stitching (at end)
<Sewing-end reverse feed stitching edit screen>
The sewing-end reverse feed stitching pat-
tern can be operated when the sewing-end
reverse feed stitching function is placed in
the ON state (
mark is not displayed).
If this function is placed in the OFF state press
the sewing end reverse feed stitch button to
switch off
mark display to enable the sew-
ing-end reverse feed stitching function.
(2) Changing the number of stitches and pitch of reverse feed stitching (at end) pattern
Change the numeric value with
❷
.
The value you have entered is conrmed by
pressing
❸
. Then, the sewing screen
is displayed.
Press
❹
to select the type of sew-
ing.
❶
❹
❸❷ ❷
In the case the reverse feed stitching or double reverse feed stitching is selected, number of stitches A
is displayed on the left side and number of stitches B is displayed on the right side on
❶
, and in
the case the condensation stitching is selected, only number of stitches A is displayed on
(display
range: 0 to 99). In the case the condensation custom is selected, the condensation custom number is
displayed on
.
❶
– 47 –
To Next Page
Loading...
Need help?
General
