JUMO dTRANS T06 - Simulation Output; Simulation Value

7 Configuration
71
7.5.10 Simulation output
An output current / output voltage can be simulated to
test the following system. It is also possible to simulate
residual currents/voltages.
OFF
ON
7.5.11 Simulation value
This value is simulated depending on the set signal
type.
for 0(4) to 20 mA;
-0.4(3.6) to 21.2 mA,
for 0(2) to 10 V:
-0.2(1.8) to 10.6 V
k SIL operation
Parameter Comment
Value range
(default setting in bold)