10 Setup program
91
10.3 Forgotten the code?
If you forget the code, it can be read out via the USB interface and the setup program.
h Use Data transfer from device.
The read-out code now appears in the setup program in the sub-menu "Display/operation".
It can be kept as it is or changed.
If "0" is set and transferred to the device, the code interrogation is deactivated and the configuration level is freely accessible.
10.4 Customer-specific linearization
Coefficients (DKD calibration values), formulas, or 40 value pairs (grid points) can be entered in the customer linearization sub-
menu.
To Next Page
Loading...
