JUMO dTRANS T06 - Limit Value Monitoring; Function

7 Configuration
73
7.6 Limit value monitoring
With this function, the relay output can monitor an adjustable limit value.
Depending on the set switching behavior, the relay output can switch to "1" or "0" in the event of limit value exceedance.
v The limit value exceedance can also trigger a fault signal, see Chapter 7.5.8 "Response for limit error"
Parameter Comment
Value range
(default setting in bold)
7.6.1 Function
(only for relay output option)
Alarm function7 (AF7): ON electrical circuit from a
fixed limit value
(1) Limit value (2) Switching differential
No function
AF7,
AF8
Alarm function8 (AF8): OFF electrical circuit from a
fixed limit value
(1) Limit value (2) Switching differential
(1)
1
x
0
(2)
(1)
1
x
0
(2)