JUMO dTRANS T06 - Service; Minimum Meas. Value; Maximum Meas. Value; Min.value Reset

7 Configuration
75
7.8 Service
7.7.2 Data format
Data bits/stop bits/parity 8/1/no parity,
8/1/odd parity,
8/1/even parity,
8/2/no parity
7.7.3 Device address
1 to 254
Parameter Comment
Value range
(default setting in bold)
7.8.1 Minimum meas. value
Minimum measured value is displayed
7.8.2 Maximum meas. value
Maximum measured value is displayed
7.8.3 Min.value reset
No, Yes
7.8.4 Max.value reset
No, Yes
7.8.5 Switching cycle limit
Limit value for relay switching cycles
Here, the limit value for the admissible relay switching
operations is set.
If the counter value for Current switching cycles is
greater than this value, the display values flash, the re-
lay output alarm drops, and the analog output goes to
the defined error value.
If "0" is set the function is inactive.
0 to 29,999
Parameter Comment
Value range
(default setting in bold)