JUMO dTRANS T06 - Page 98

11 Error messages
98
Software versions Internal device The software versions of the safety channel and diagnostics channel do not
match. Restart device / return device.
Internal comm.
Internal device Communication between safety channel and diagnostics channel faulty.
Restart device / return device.
Editing procedure Internal device An error has occurred during editing.
Restart device / return device.
Relay switch cycle Internal device The configured limit of the switching cycles has been exceeded.
The error can be remedied by reducing the current counter or increasing the limit.
v Chapter 7.8.5 "Grenze Schaltspiele"
Config. faulty
Internal device The configuration is faulty
h Check configuration
ROM defective Internal diagnos-
tics
A ROM error has occurred. Restart device / return device.
RAM defective
Internal diagnos-
tics
A RAM error has occurred. Restart device / return device.
Parameter faulty
Internal diagnos-
tics
Parameter faulty
h Check configuration
CRC Test RAM
Internal diagnos-
tics
CRC test of configuration in RAM returned an error
Restart device / return device.
CRC Test EEPROM
Internal diagnos-
tics
CRC test of configuration in EEPROM returned an error
Restart device / return device.
Program sequence Internal diagnos-
tics
Program sequence faulty. Restart device / return device.
Display Origin Cause/remedy