08.11 EN
146
Boom
Video system
Weigher sensors / switches
Weather-proof system
Wiper/washer system
Test operation and setting of the attachment.
Check attachment for damage.
t
Check piston and piston rod for damage, check setting and adjust if
necessary.
t
Check that hydraulic ports, hose and pipe lines are secure, check for
leaks and damage.
t
Attachment:
check bearing points, guides and stops for wear and damage,
grease and clean these components.
t
Check attachment is properly secured to the truck and the
supporting elements.
t
Hydraulic operations W A B C
Check attachment is properly secured to the truck and the
supporting elements.
t
System components W A B C
Test camera, make sure it is secured and clean. t
Test monitor, make sure it is secured and clean. t
Check wiring is secure and check for damage. t
Electrical System W A B C
Test weigher system and check for damage. t
Electrical System W A B C
Check fuse ratings. t
Chassis and superstructure W A B C
Test doors and check for damage. t
Test windscreen heating and check for damage. t
Chassis and superstructure W A B C
Test windscreen wipers and check for damage, replace if necessary. t
Check wiper water container for leaks and check volume, top up if
necessary.
t
Hydraulic operations W A B C
To Next Page
Loading...
Need help?
General
