Juniper MX204 - Connecting the MX204 to the Network; Tools and Parts Required to Connect the MX204 Router to External Devices

4. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
5. Switch off the power supply source.
SEE ALSO
request vmhost halt
Connecting the MX204 to the Network
IN THIS SECTION
Tools and Parts Required to Connect the MX204 Router to External Devices | 101
Connecting the MX204 Router to External Devices and Cables | 102
Tools and Parts Required to Connect the MX204 Router to External Devices
To connect the router to external devices, you need the following tools and parts:
•
2.5-mm flat-blade (–) screwdriver for the alarm relay contacts
•
Electrostatic discharge (ESD) grounding wrist strap (provided in the accessory kit)
SEE ALSO
Verifying the MX204 Router Parts Received | 80
Prevention of Electrostatic Discharge Damage | 173
101