EasyManuals Logo

JVC GY-HC500E User Manual

JVC GY-HC500E
268 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
2
Select the framing mode for the time code
generator
(only when the frame rate setting
is ā€œ60ā€ or ā€œ30ā€).
To configure the setting, go to [TC/UB] B [Drop
Frame].
(A P
126 [ Drop Frame ] )
0
[Drop]:
Sets
the run mode of the time code generator
to drop frame mode. Use this setting when
placing emphasis on the recording time.
0
[Non Drop]:
Sets the run mode of the time code generator
to non-drop frame mode. Use this setting
when placing emphasis on the number of
frames.
Memo :
Drop frame/non-drop frame mode
0
When [System] B [Record Set] B [Record
Format] B [Frame Rate
] is set to ā€œ60pā€, ā€œ60iā€, or
ā€œ30pā€, the actual number of frames per second
is approximately 59.94 (29.97). However, the
time code processing standard is ā€œ60pā€, ā€œ60iā€, or
ā€œ30pā€ frames. To make up for the frame number
discrepancy, the drop frame mode (Drop) drops
the 00 frame and 01 frame every minute except
for minutes that are multiples of 10. However, in
the case of ā€œ60pā€, the 00, 01, 02 and 03 frame
are dropped.
0
The
non-drop frame mode (Non Drop) does not
drop frames and ignores the discrepancy with
the actual time.
Setting Time Code
1
Select [TC/UB] B [TC Preset
] and press the
Set button (R).
(A P125
[ TC Preset ] )
The [TC Preset] screen appears.
.
1
TC Preset
00:00:00:00
TC/UB
Memo :
0
When [TC/UB] B [TC Generator] is set to
ā€œRegenā€, the parameter is displayed as
ā€œ<Regen>ā€ and cannot be selected.
(A P125 [ TC Generator ] )
2
Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
.
During drop frame
During non-drop
frame
Cursor
TC Preset
00:00:00:00
TC/UB
Memo :
0
Press the [OIS/2] button to reset each digit to ā€œ0ā€.
The cursor moves to the time digit (left).
3
Check the values and press the Set button
(R).
0
The time code is set and the screen returns
to [TC/UB].
0
To cancel the setting, press the [CANCEL]
button.
4
Press the [MENU/THUMB] button.
Returns to the normal screen.
78
Setting Time Code Generator
Shooting

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC GY-HC500E and is the answer not in the manual?

JVC GY-HC500E Specifications

General IconGeneral
BrandJVC
ModelGY-HC500E
CategoryCamcorder
LanguageEnglish

Related product manuals