KEB COMBIVERT F5 Reference Manual

140
LI - Input Parameters
When this function is turned on, it allows the controller to command the
drive to switch between correction and inspection speeds. This parameter
only applies to Binary Speed Control (1).
LI60 OFF
1. If you start in correction speed and drop the enable while still running a
Drive Enable Switched off is logged.
2. If you start in High speed and drop the enable while still running a
Drive Enable Switched off is logged.
This is expected behavior for both situations.
LI60 ON
1. If you start in correction speed and transition to either inspection or
stay in correction and drop the enable while running no Drive Enable
Switched off is logged.
2. If you start in High speed and drop the enable while still running a
Drive Enable Switched off is logged.
LI60
Correction / Inspection

KEB COMBIVERT F5 Specifications

General

Category	DC Drives
Enclosure Rating	IP20
Control Mode	Vector Control, V/f Control
Protection	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Fieldbus Communication	PROFIBUS, CANopen
Communication Interfaces	RS-485
Input Voltage	380-480V AC
Cooling Method	Forced air cooling (fan)