KEB COMBIVERT F5 Reference Manual

189
LC - Control Setting Parameters
The integral offset gain for acceleration.
This offset acceleration gain will assist the motor in catching the load during
starting. It is especially important for high efficiency geared or gearless
applications. Values of 2,000 to 5,000 are useful.
Integral Offset Acceleration Correct
Integral Offset Acceleration Too Low (500) - Speed lags command on take off
Integral Offset Acceleration Too High (6000) - Vibration at take off
LC11
KI Offset Acceleration

KEB COMBIVERT F5 Specifications

General

Category	DC Drives
Enclosure Rating	IP20
Control Mode	Vector Control, V/f Control
Protection	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit
Fieldbus Communication	PROFIBUS, CANopen
Communication Interfaces	RS-485
Input Voltage	380-480V AC
Cooling Method	Forced air cooling (fan)