Keithley 4200A-SCS User Manual

Section 5: KPulse (for Keithley Pulse Cards) Model 4200A-SCS Pulse Card (PGU and PMU) User's Manual
5-10 4200A-PMU-900-01 Rev. A December 2020
3. Select the Waveform Type to be created.
4. Configure the Settings for the selected waveform type.
5. Select Preview to update the preview of the waveform.
6. In the Waveform Name field, type in a name for the waveform. You cannot use a name that is
already used in the Scratch Pad.
7. Select OK to create the waveform. The new waveform is added to the Scratch Pad.
8. Repeat these steps to create another waveform in the Scratch Pad.
Custom Arb file operation: Copy waveforms into Sequencer
To copy waveforms into the Sequencer:
1. Select the Arb Generator tab.
2. Select Scratch Pad or Sequencer:
▪ Scratch Pad previews the waveform that is selected in the Scratch Pad.
▪ Sequencer previews enabled waveform sequences. To preview the waveforms in the
Sequencer, select Enable Channel 1 or Enable Channel 2.
3. Select the scale for the graph, Points Scale or Time Scale.
4. In the Scratch Pad, select a waveform to be copied into the Sequencer.
5. Select Channel 1 to copy the selected waveform onto the Sequencer for Channel 1 or select
Channel 2 to copy the waveform into the Sequencer for Channel 2. You can copy the same
waveform to both channels.

Keithley 4200A-SCS Specifications

General

Brand	Keithley
Model	4200A-SCS
Category	Measuring Instruments
Language	English