Keithley 4200A-SCS - Page 9

Table of contents Model 4200A-SCS Pulse Card (PGU and PMU) User's Manual
Use the RPM to switch the SMU, CVU, and PMU ................................................... 6-1
Introduction .......................................................................................................................... 6-1
Equipment required .............................................................................................................. 6-1
Update the RPM configuration in KCon ............................................................................... 6-2
Device connections .............................................................................................................. 6-3
Connection schematic ............................................................................................................... 6-3
Connect the 4200A-SCS to the DUT ......................................................................................... 6-4
Set up the measurements in Clarius .................................................................................... 6-5
Create a new project ................................................................................................................. 6-5
Add a device ............................................................................................................................. 6-6
Search for and select existing tests in the Test Library ............................................................. 6-6
Configure the vfd test ................................................................................................................ 6-8
Configure the cv-diode test ..................................................................................................... 6-10
Configure the pulse-diode test ................................................................................................ 6-12
Run the test ............................................................................................................................. 6-14
View and analyze the test results ............................................................................................ 6-15
PMU for pulsed I-V measurements on a MOSFET ................................................. 7-1
Introduction .......................................................................................................................... 7-1
Equipment required .............................................................................................................. 7-2
Device connections .............................................................................................................. 7-2
Connection schematic ............................................................................................................... 7-3
Set up the measurements in Clarius .................................................................................... 7-4
Create a new project ................................................................................................................. 7-4
Search for and select an existing test ....................................................................................... 7-5
Configure the test ...................................................................................................................... 7-6
Run the test and analyze the results ......................................................................................... 7-8
Testing flash memory .............................................................................................. 8-1
Testing flash memory ........................................................................................................... 8-1
Flash connection guidelines ................................................................................................. 8-3
Programming and erasing flash memory .................................................................................. 8-3
Endurance testing ................................................................................................................ 8-9
Connections for endurance testing - no switch matrix ............................................................... 8-9
Connections for endurance testing - switch matrix .................................................................. 8-11
Disturb testing .................................................................................................................... 8-12
Connections for disturb testing ................................................................................................ 8-12
Using a switch matrix ......................................................................................................... 8-14
Use KPulse to create and export Segment Arb waveforms............................................... 8-15
Enter Segment Arb values into UTM array parameters ..................................................... 8-16
Direct connections to single DUT ....................................................................................... 8-17
Direct connections to array DUT for disturb testing ........................................................... 8-19