106 | 09 Creating your own voices
At the bottom of the screen:
• The first button allows you to switch between the 24 factory Drawbar presets.
• LOW DRIVE: AMOUNT/LP: Adjust the amount of the Overdrive and the frequency of
the low-pass filter that intervenes in the simulation of the rotating speaker of the
woofer of the Leslie cabinet.
• HIGH DRIVE: AMOUNT/LP: Adjust the amount of the Overdrive and the frequency of
the low-pass filter that intervenes in the simulation of the rotating horns of the Leslie
cabinet.
• KEY CLICK AMOUNT: Check the click level, from 0 to 127.
• REVERB SEND: Adjust the send to the reverb effect, from 0 to 127.
• ROTOR PRESET: Choose a factory setting of the rotary effect from the seven available.
• GLOBAL LEVEL: Check the global voice volume level, from 0 to 127.
• The ROTOR PARAMETER button allows you to control:
o HIGH ROTOR/LOW ROTOR: adjust the top and bottom; the rotor
(rotating speaker of the woofer) and the horns.
o The SOUND REFLECTION configuration includes three configurable
parameters with values from 0 and 127: DIRECT SOUND is the amount
of sound that propagates directly without reflection, REFLECTION
INTENSIVITY represents the intensity with which the sound wave
reflects with an angle of incidence when it encounters walls and
obstacles, while REFLECTION DELAY determines thedelay of the sound
that returns after bouncing against a wall or obstacle.
• IMPORT ed EXPORT: permettono il salvataggio e il caricamento dei 24 suoni di
organo.
Expert Advice
The instrument has to ability to receive the volume control of Drawbars via Sysex:
F0 26 7B 48 05 Drawbar number (0-8), Vol (0-7f) F7
Drum Set Remapping
This is a function can be open by the three buttons of the DRUM SET REMAP area on the
screen within the DRUM SET function.
To Next Page
Loading...
