Keysight Technologies 34410A - Setting up a LAN Connection from the Remote Interface

34410A/11A/L4411A User’s Guide 99
Remote Interface Configuration 3
Setting up a LAN connection from the Remote Interface
Use the following SCPI commands to configure the LAN interface.
• To enable or disable the LAN remote interface:
SYSTem:COMMunicate:ENABle {OFF>0>ON>1},LAN
• To enable or disable the use of DHCP for the LAN interface:
SYSTem:COMMunicate:LAN:DHCP {OFF>0>ON>1}
• To enable or disable the use of Auto–IP for the LAN interface:
SYSTem:COMMunicate:LAN:AUTOip[STATe] {OFF>0>ON>1}
• To assign the LAN a static IP address:
SYSTem:COMMunicate:LAN:IPADdress “< address >”
• To assign a LAN Subnet Mask:
SYSTem:COMMunicate:LAN:SMASk “< mask >”
• To assign a LAN Default Gateway:
SYSTem:COMMunicate:LAN:GATEway “< address >”
• To assign a LAN Host Name:
SYSTem:COMMunicate:LAN:HOSTname “< name >”
• To assign the LAN a static DNS address:
SYSTem:COMMunicate:LAN:DNS “< address >”
• To assign a LAN Domain Name:
SYSTem:COMMunicate:LAN:DOMain “< name >”
Query forms of these commands are also available. Refer to the Keysight
34410A/11A/L4411A Programmer’s Reference Help for complete command description
and syntax.
NOTE
If you disable or re–enable the LAN interface, you must cycle the power for the change
to take effect. You must also cylcle power when you disable or re–enable any of the
LAN services, or change any LAN settings from the remote interface using SCPI
commands.