128 34410A/11A/L4411A User’s Guide
5 Specifications
These specifications apply when using the 34410A/11A/L4411A multimeter in an
environment that is free of electromagnetic interference and electrostatic charge.
When using the multimeter in an environment where electromagnetic interference or
significant electrostatic charge is present, measurement accuracy may be reduced.
Particularly note:
• The voltage measurement probes are not shielded and can act as antennas, causing
electromagnetic interference to be added to the signal being measured.
• Electrostatic discharges of 4000 V or greater may cause the multimeter to temporarily
stop responding, resulting in a lost or erroneous reading.
Specifications are subject to change without notice. For the latest specifications, see
the product datasheet on the Web. Firmware updates may also be available on the Web.
Start at either product page:
www.keysight.com/find/34410A
www.keysight.com/find/34411A
www.keysight.com/find/L4411A
The specifications on the following pages are valid for the Keysight 34410A,
34411A, and L4411A multimeters with firmware revision 2.05, or later.
To Next Page
Loading...
