Keysight Technologies U1253B - Figure 4-10 Choosing the Sound Used in Continuity Test; Sound Setting for Continuity Test

Changing the Default Settings 4
Keysight U1253B User’s and Service Guide 123
Sound setting for continuity test
This setting determines the sound used in the continuity test. Select "SINGLE" for
a single-frequency beep, select “OFF” for a silent beep, or select "TONE" for a
continuous string of beeps with varying frequencies.
Figure 4-10 Choosing the sound used in continuity test
Press Hz
to edit
Press Hz to save
and exit
or press Esc
to exit without saving
to switch between
SINGLE, OFF and TONE
Press or