Keysight Technologies U1253B - Figure 4-25 Setting Initial Measurement Functions

4 Changing the Default Settings
138 Keysight U1253B User’s and Service Guide
For another example, when you turn the rotary switch to the position, the
initial measurement range is Auto according to default factory setting. In order to
choose a different range, you will have to press the button.
If you prefer to have a different set of initial measurement functions, change the
M-INITIAL setting to USER, and press the button. The multimeter will then
enter the INIT pages. Please refer to Figure 4-25.
Figure 4-25 Setting initial measurement functions
In the INIT pages, you may define your preferred initial measurement functions.
Please refer to Figure 4-26.
Press or to navigate between the two INIT pages. Press or to choose
which initial function you want to change.
to switch between
FACTORY and USER
Press or
Press Hz
to edit
Press Hz to save
and exit
If USER
is selected
If FACTORY
is selected
to INIT pages
initial measurement
for setting up
Press Hz to proceed