Keysight Technologies U1253B - Figure 4-26 Navigating between the Initial Functions; Figure 4-27 Editing Initial Measurement Function;Range

Changing the Default Settings 4
Keysight U1253B User’s and Service Guide 139
Figure 4-26 Navigating between the initial functions pages
Then press to enter the EDIT mode.
In the EDIT mode, Press or to change the initial (default) measurement
range of a selected function. For example, Figure 4-27 below shows the initial
range of the AC voltage measurement function at the F1 position changed to
1000 V (default was Auto).
Press or to change the initial measurement function of a selected rotary
switch position. For example, Figure 4-27 below shows the initial measurement
function of the F5 position changed from DIODE to FC (frequency counter).
Figure 4-27 Editing initial measurement function/range
or
Press
Press or
to choose item
Press or
to choose item
Edit F1 initial range
and F5 initial function