Keysight Technologies U1253B - Figure 4-18 Data Bits Setup for Remote Control; Setting Data Bits

Changing the Default Settings 4
Keysight U1253B User’s and Service Guide 131
Setting data bits
The number of data bits (data width) for remote communication with a PC can be
set to either 8 or 7 bits. The number of stop bit is always 1, and this cannot be changed.
Figure 4-18 Data bits setup for remote control
to switch between
7 and 8
Press Hz
to edit
Press or
Press Hz to save
and exit
or press Esc
to exit without saving