4 Changing the Default Settings
134 Keysight U1253B User’s and Service Guide
Setting print mode
Turning print mode “ON” enables the printing of measured data to a PC that is
connected to the multimeter via the remote interface when a measurement cycle
is completed.
In this mode, the multimeter continuously sends the latest data to the host, but
does not accept any commands from the host.
The indicator flashes during print operation.
Figure 4-21 Print mode setup for remote control
to switch between
OFF and ON
Press or
Press Hz
to edit
Press Hz to save
and exit
or press Esc
to exit without saving
To Next Page
Loading...
