Keysight DSOX3034T User Manual

215
Keysight InfiniiVision 3000T X-Series Oscilloscopes
User's Guide
13 Acquisition Control
Running, Stopping, and Making Single Acquisitions (Run Control) / 215
Overview of Sampling / 217
Selecting the Acquisition Mode / 221
Realtime Sampling Option / 227
Acquiring to Segmented Memory / 229
This chapter shows how to use the oscilloscope's acquisition and run controls.
Running, Stopping, and Making Single Acquisitions (Run Control)
There are two front panel keys for starting and stopping the oscilloscope's
acquisition system: [Run/Stop] and [Single].
• When the [Run/Stop] key is green, the oscilloscope is running, that is, acquiring
data when trigger conditions are met.
To stop acquiring data, press [Run/Stop]. When stopped, the last acquired
waveform is displayed.
• When the [Run/Stop] key is red, data acquisition is stopped.
"Stop" is displayed next to the trigger type in the status line at the top of the
display.
To start acquiring data, press [Run/Stop].
• To capture and display a single acquisition (whether the oscilloscope is running
or stopped), press [Single].

Keysight DSOX3034T Specifications

General

Brand	Keysight
Model	DSOX3034T
Category	Test Equipment
Language	English