301
Keysight InfiniiVision 3000T X-Series Oscilloscopes
User's Guide
19 Waveform Generator
To select generated waveform types and settings / 301
To edit arbitrary waveforms / 305
To output the waveform generator sync pulse / 312
To specify the expected output load / 312
To use waveform generator logic presets / 313
To add noise to the waveform generator output / 313
To add modulation to the waveform generator output / 314
To restore waveform generator defaults / 318
A waveform generator is built into the oscilloscope. It is enabled by the
DSOX3WAVEGEN upgrade license. The waveform generator gives you an easy
way to provide input signals when testing circuitry with the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope setups.
See Chapter 20, “Save/Email/Recall (Setups, Screens, Data),” starting on page
321.
To select generated waveform types and settings
1 To access the Waveform Generator Menu and enable or disable the waveform
generator output on the front panel Gen Out BNC, press the [Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is illuminated.
When waveform generator output is disabled, the [Wave Gen] key is off.
The waveform generator output is always disabled when the instrument is first
turned on.
To Next Page
Loading...
Need help?
General
