Keysight DSOX3034T - 1 Getting Started

Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide 7
In This Guide
This guide shows how to use the InfiniiVision 3000T X-Series oscilloscopes.
When unpacking and using the
oscilloscope for the first time, see:
• Chapter 1, “Getting Started,” starting on page 27
When displaying waveforms and
acquired data, see:
• Chapter 2, “Horizontal Controls,” starting on page 63
• Chapter 3, “Vertical Controls,” starting on page 79
• Chapter 4, “FFT Spectral Analysis,” starting on page 89
• Chapter 5, “Math Waveforms,” starting on page 99
• Chapter 6, “Reference Waveforms,” starting on page
127
• Chapter 7, “Digital Channels,” starting on page 131
• Chapter 8, “Serial Decode,” starting on page 149
• Chapter 9, “Display Settings,” starting on page 155
• Chapter 10, “Labels,” starting on page 161
When setting up triggers or changing
how data is acquired, see:
• Chapter 11, “Triggers,” starting on page 169
• Chapter 12, “Trigger Mode/Coupling,” starting on
page 207
• Chapter 13, “Acquisition Control,” starting on page
215
Making measurements and analyzing
data:
• Chapter 14, “Cursors,” starting on page 233
• Chapter 15, “Measurements,” starting on page 243
• Chapter 16, “Mask Testing,” starting on page 275
• Chapter 17, “Digital Voltmeter and Counter,” starting
on page 289
• Chapter 18, “Frequency Response Analysis,” starting
on page 295
When using the built-in license
enabled waveform generator, see:
• Chapter 19, “Waveform Generator,” starting on page
301
When saving, recalling, or printing,
see:
• Chapter 20, “Save/Email/Recall (Setups, Screens,
Data),” starting on page 321
• Chapter 21, “Print (Screens),” starting on page 335