Save/Email/Recall (Setups, Screens, Data) 20
Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide 325
2 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See “To navigate storage locations" on page 329.
3 Press the Settings softkey.
In the File Settings Menu, you have these softkeys and options:
• Setup Info — when enabled, setup information (vertical, horizontal, trigger,
acquisition, math, and display settings) is also saved in a separate file with a
TXT extension.
• Length — sets the number of data points that will be output to the file. For
more information, see “Length Control" on page 326.
• Save Seg — when data is acquired to segmented memory, you can specify
whether the currently displayed segment is saved or all acquired segments
are saved. (See also “Saving Data from Segmented Memory" on page 231.)
4 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
CSV Data When the CSV data (*.csv) file format is selected, comma-separated values for
each displayed waveform and digital channel pod are saved as multiple columns
in a single file. Math FFT waveforms, whose values are in the frequency domain,
are appended at the bottom of the .csv file. Pod names (for example, D0-D7) or
waveform labels are used as column headers. This format is suitable for
spreadsheet analysis.
For CSV data, length "N" value-at-time measurements are performed across the
entire screen (using the measurement record data) for each active source.
Interpolation between measurement record data points is performed as needed.
ASCII XY Data When the ASCII XY data (*.csv) file format is selected, comma-separated value
files for each displayed waveform, digital channel pod, digital bus, and serial bus
are saved. For digital pods, an underscore (_) and the pod name (for example,
D0-D7) are appended to the specified file name; otherwise, an underscore and the
waveform's label are appended.
If the oscilloscope acquisition is stopped, data from the raw acquisition record
(which has more points than the measurement record) can be written. Press the
[Single] key to obtain maximum memory depth with current settings. If enabled,
serial decode data is saved.
To Next Page
Loading...
Need help?
General
