KGuard Security HD881 - Safety Precautions; Electrical Safety; Environmental and Personal Safety

Hybrid DVR (HD Series)
3
Safety Precauons
• Do not touch live electrical parts.
Electric shock can be avoided. Follow the recommended pracces listed below. Faulty
installaon, improper grounding, and incorrect operaon and maintenance of electrical
equipment are always sources of danger.
• Do not try to install equipment outdoor, during strong wind and rain.
• Do not install or remove equipment outdoor, when raining.
• Do not try to install or operate any equipment, during a thunderstorm.
• Always ground all electrical equipment and the work plaorm.
Prevent accidental electrical shocks. Connect power source, control cabinets, and work
plaorm to an approved electrical ground.
• Always use the correct cable size.
Sustained overloading will cause cable failure and result in possible electrical shock or
re hazard. Work cable should be the same rang as the factory.
• Always keep cables and connectors in good condion.
Improper or worn electrical connecons can cause short circuits and can increase the
chance of an electrical shock. Do not use worn, damaged, or bare cables.
• Always avoid open-circuit voltage.
The added voltages increase the severity of electric shock hazard.
• Always wear insulated gloves while you adjust equipment.
Electric power should be turned o and insulated gloves should be worn when making
any equipment adjustment to assure shock protecon.
• Always wear protecve clothing such as long sleeve shirts while you are installing or
removing equipment.
• Always wear high, snug ng shoes.
• Always wear clean clothes without grease or oil.
• Protect neighboring workers from exposure to arc radiaon.
• Always wear long trousers or jeans while you are installing or removing equipment.
• Always wear safety helmet or hard hat and safety shoes before work.
• Always keep the equipment in dry places.
• Always wear safety harnesses/belt while you work in high places.
• Always wear dry clothing and avoid moisture and water.
• Always wear Public Safety Vest, while you work at night.
• Make sure all electrical connecons are ght, clean, and dry.
• Make sure that you are well insulated to eliminate electric stac charge.
• Always wear dry gloves, rubber-soled shoes, or stand on a dry board or plaorm.
• Always follow recognized safety standards.
• Always wear correct eye, ear, and body protecon.
• Always have second person on-site, while you work in dark, poor venlaon, or high
places.
• Make sure that you are well protected against arc ashes, mechanical injury, or other
mishaps.
• Make sure that the polarity of wire is correct before installing equipment.
• Always handle equipment with care.
• Do not block the venlaon of equipment.
• Do not put the magnec parts around the equipment.
• Do not put the objects on top of the equipment.