Kinco FD3&CD3 User Manual
9.3 F003
This panel menu contains parameter for the configuration of analog and digital I/O functions.
Controller->Panel Menu->F003 DI/DO & Operation Mode Setting(F003)
Table 9-3: Panel F003 parameters
Save or init parameters
1: save control parameters
10: init control parameters
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
See chapter 6.1, table 6-1
Simulates input signals, and enforce
output signals for outputting
0: no operation
1: auto-enable when logic power-up.
Can be set only if the DIN function
enable is not defined.
See chapter 6.1, table 6-2
See chapter 6.1, table 6-2
See chapter 6.1, table 6-2
See chapter 6.1, table 6-2
See chapter 6.1, table 6-2
Operation mode channel 0: select via
input port
Operation mode channel 1: select via
input port
See chapter 6.2.2, table 6-8
unit: rpm
See chapter 6.2.2, table 6-8
unit: rpm
See chapter 6.2.2, table 6-8
unit: rpm
See chapter 6.2.2, table 6-8
unit: rpm
Filter parameter of analog signal 1
To Next Page
Loading...
