Kinco CD3 Series - Things to Note

Kinco FD3&CD3 User Manual
12
2.2.7 Things to note
 Warning
 Please operate in strict accordance with the requirements of this manual，
Refer to Figure 2-3 and Figure 2-4 for correct installation of the servo system.
 The servo driver should be mounted vertically on the wall. When fixing the
drive, make sure that each fixing screw is locked tightly.
 Do not plug the driver vents. When installing brake resistors, cooling space
around the driver should be incubated so that the servo driver will not be
affected.
 Avoid any foreign matter entering the servo driver, such as screws, metal
scraps and other conductive foreign matter or combustible foreign matter
entering the servo drive may cause fire and electric shock.

For safety reasons, please do not use damaged or damaged servo drivers and
servo motors.

The driver and motor power cable, lock cable and encoder cable should be fixed
and not overstretched.
 The servo driver and servo motor must be well grounded.
Figure 2-3 CD&FD413 423 Installation direction and requirements