Kinco CD3 Series - Technical Requirements; Qualification of the Specialists; Range of Application and Certifications; Environment Requirements

Kinco FD3&CD3 User Manual
11
2.2.3 Technical requirements
General conditions for correct and safe use of the product, which must be observed at all times:
 Comply with the connection and environmental conditions specified in the technical data of the product
and of all connected components.
Compliance with limit values and load limits is mandatory in order to assure operation of the product in
accordance with the relevant safety regulations.
 Observe the instructions and warnings in this documentation.
2.2.4 Qualification of the specialists
The product may only be placed in operation by a qualified electrician who is familiar with:
– Installation and operation of electrical control systems
– Applicable regulations for operating safety-engineered systems
– Applicable regulations for accident protection and occupational safety
– Documentation for the product
2.2.5 Range of application and certifications
Certificates and declaration of conformity for this product can be found at
https://www.kinco.cn/download/ydkz23.html
The product has been certified by Underwriters Laboratories Inc. (UL) for the USA and Canada and is
marked as follows:
UL listing mark for Canada and the United States
UL listing mark for the United States
2.2.6 Environment requirements
Environment
Requirement
Working temperature
0 - 40℃ (no ice)
Working humidity
5 - 95%RH (no condensation)
Storage temperature
-10 - 70℃ (no ice)
Storage humidity
5 - 95%RH (no condensation)
Assembly requirement
Indoors without sunlight, corrosive gas, non-flammable gas, no dust.
Altitude
Less than 2000 m, power derating between 1000m and 2000m
Vibration
Less than 5.9m/s2, 10〜60Hz (not to be used at the resonance point)