Kinco CD3 Series - Power Connector (X2); RS232 Port（X3

Kinco FD3&CD3 User Manual
21
Figure 3-6 ground schematic
3.3 Power connector (X2)
Table 3-3: Power connector
3.4 RS232 port
（
X3
）
Table 3-3: RS232 port
Pin
Function
L1C
Control power input L/N
Single phase 200 – 240VAC ±10% 50 / 60Hz, 0.5A
Supply earthing systems: TN-S, TN-C, TN-C-S, TT (not corner earthed).
L2C
L1
Drive power input L/N
Single phase 200 – 240VAC ±10%, 50 / 60Hz
750W @7A, 400W @4.5A, 200W @3A, 100W @1.5A
Supply earthing systems: TN-S, TN-C, TN-C-S, TT (not corner earthed).
L2
DC+
/RB1
DC+
DC bus+
Information
Short circuit DC+ / RB1 and RB2 if choosing
controller internal braking resistor (power: 10 W)
Note
It is forbidden to use the internal braking resistor
if the average brake power is more than 10 W.
RB1
External braking
resistor input
RB2
Internal braking
resistor input
RB-
External braking
resistor input
DC-
DC bus-
U/V/W
U/V/W phase power output for servo motor