Kinco CD3 Series - Chapter 12 RS485 Communication

Kinco FD3&CD3 User Manual
117
Chapter12 RS485 Communication
12.1 RS485 communication interface
The X6 interface of FD3 Servo driver supports RS485 communication.The wiring diagram is shown in following figure.
Pin definition can be found in Chapter 3.
12.2 RS485 communication parameters
LED
Display
Name
Meaning
Default Value
d5.01
ID_Com
Station No. of Drivers
Note: To change this parameter, you
need to save it with the address
“d5.00”, and restart it later.
1
RS485_Bandrate
Set the baud rate of RS485 port
Note: This parameter must be
changed in KincoServo software.
540
Other parameters
Data bit = 8
Stop bit = 1
Parity = None
Constant