Kinco CD3 Series - Driver Usage Requirements; Requirements for Product Use; Transport and Storage Conditions

Kinco FD3&CD3 User Manual
10
 Notice！
 Pay attention to the danger of electric shock：
 The cable must be attached to the plug (X2).
 Be sure to disconnect the power when connecting the cables.
 Contact with live parts can cause serious injury and may result in death.
 This product must be installed in the electrical box when used, and all
protection measures have been started.
 Care should be taken before touching live parts during maintenance, repair
and cleaning work and during long service interruptions：
 Turn off the power supply of electrical equipment by means of a power switch
and prevent it from being turned on again.
 When the power is off, check the charging indicator at the front of the
device.If the light goes out, you can touch the driver.
2.2 Driver usage requirements
2.2.1 Requirements for product use
 Make this documentation available to the design engineer, installer and personnel responsible for
commissioning the machine or system in which this product is used.

Make sure that the specifications of the documentation are always complied with. Also consider the
documentation for the other components and modules.
 Take legal regulations applicable at the destination into consideration, as well as:
– Regulations and standards
– Regulations of testing organizations and insurers
– National specifications
2.2.2 Transport and storage conditions
 Protect the product during transport and storage from impermissible loads such as:
– Mechanical load
– Impermissible temperatures
– Moisture
– Aggressive atmospheres
 Store and transport the product in its original packaging. The original packaging offers sufficient
protection from typical stressing.