3. Parameters setting in controller
Copy Kinco servo device file Kinco_servo.xml to the installation folder of Sysmac Studio software of NJ
series controller. For example:
C:\Program Files\OMRON\Sysmac Studio\IODeviceProfiles\EsiFiles\SystemEsiFiles
Use a standard Ethernet cable to connect PC and NJ controller. Open Sysmac Studio software to create a
new project. Choose the model and version information. They can be fond on the product label of controller.
After created project, double click Configurations and Setup at left side, and then set the parameters of
master station at right side (normally use default values).
To Next Page
Loading...
