Kinco FD3&CD3 User Manual
● When operators need to disassemble pulleys, operators need to use pulley remover so as to make
shaft avoid strong impact of load.
● In order to make it more safe, it is necessary to install protection cover or some analogous
equipment in rotation area. For example, pulleys installed on the shaft.
●When it is connected with machine, please use coupling and make shaft center of servo motor and
machine stay in a line. When operators install servo motors, please achieve requirements of centering
accuracy. If centering is not accurate, there will be shock and sometimes it will make bearings and
encoders.
● Servo motors can be installed in vertical or horizontal direction.
When it is used in the occasion with drops, please use after make sure protection level of servo. When
oil will drop into shaft penetrating part (beside shaft penetrating part, please choose servo motors with
oil seal. The using condition of servo motors with oil seal:
● Make sure the oil level is lower than month of oil seal.
● Please use when oil seal make sure that oil splash degree is good.
● When servo motors are installed in vertical upward direction, please avoid oil accumulating in the
month of oil seal.
Please do not make cable bending or pull the cable. When using it, please do not make it too tight.
In terms of connectors, please note the following:
● When connectors are connected. please make sure there is no foreign body such as trash
or mental slices.
● When connectors are connected into servo motors, please connect to one side of servo
motor's main circuit cable and make sure ground cable of main cable connecting stably. If
operators first connect one side of encoder cable, then, encoder may have some faults
because of voltage difference between PEs.
● During the process of wiring, please make sure pin arrangement is correct.
● Connector is made of resin. Please do not add pressure to avoid damage of connectors.
● When handling operations is done (cables are connected), please hold main body of servo
motors. If operators just hold cable to handle, it may cause connectors damage or make
cable cut off.
● If operators use bend cable, please do not add pressure to connectors during the process
of wiring. If pressure is added to connectors, it will cause connector damage.
To Next Page
Loading...
